Oxy Stain Remover
Sodium Percarbonate, Extenders.
Top-Load & HE Washers: 1 scoop per load. Begin filling washer with proper temperature water for your load (see garment tag). As with detergent, add oxy cleaner to the wash water before adding laundry. Laundry Pre-Treat: 1 scoop per gallon of water. Apply solution to stain. Rub and wait up to 10 minutes. Do not allow to dry on fabric. For laundry, wash as normal with detergent and oxy cleaner. For non-laundry water-washable fabrics and surfaces, blot well with a white towel. Rinse item thoroughly and allow to dry. Repeat as required. Soaking: Up to 2 scoops per gallon of water. Add item. Soak for 1 to 6 hours. Remove item. Rinse thoroughly for non-washable fabric or wash as normal with detergent and oxy cleaner. Carpet Spot Remover: Up to 1/4 scoop per gallon of water. Remove excess liquid before treating stain. Apply only enough solution to saturate stain. Allow solution to stand 1 to 5 minutes. Blot well with a white towel. Repeat as required. Rinse well with water and blot thoroughly. Allow to dry, then vacuum. Outdoors: Up to 1/2 scoop per gallon of water. Pour or sponge oxy cleaner solution from a bucket onto awnings, siding, decks, and lawn furniture. Allow solution to stand 5 to 30 minutes. Scrubs as required. Rinse well with cool water. Work small areas so that your solution doesn't dry on surface. Household Stains: Up to 1/8 scoop per gallon of water. For counters, fabrics, kitchen floors, trash cans, upholstery, and water washable household surfaces, apply solution to surface or stain. Allow to stand for 5 to 30 minutes. Scrub with sponge or blot with towel. Rinse thoroughly and allow to dry. Tile & Grout: 2 scoops. Mix solution into a gritty paste by slowly adding a very small amount of water. Apply with rubber gloves and allow to stand for one hour. Scrub surface and rinse thoroughly with water. Directions for Stain Removal: Add to every laundry load with detergent. A chlorine-free and color safe alternative to chlorine bleach. Mix until completely dissolved. Use mixed solution within 6 hours. Usage Guidelines: Test in an inconspicuous area first. Rinse, then allow to dry. Always follow the manufacturer's instructions for water temperature and for cleaning garment or item. Oxy cleaner works best in warm or hot water. Treat stains while fresh. Always rinse well with cool water. Do not place fabric that has not been thoroughly rinsed into dryer. Do not use on wool, wool blends, silk, silk blends, leather or on fabrics labeled dry clean only. Not for use on jewelry, latex paints, woven baskets, unpainted wicker, jute, teak or finished woods. Metals must not be soaked and must be rinsed immediately and thoroughly. Not for use on rust, dried paint or bleached damage. Safe for septic tanks. Keep container closed and dry between uses. Some stains will require repeated, longer and stronger treatments. Adding more oxy stain remover powder than directed increases the risk of color loss. If washing in cold water, pre-dissolve oxy stain remover first in 16 oz of warm to hot water. Add to cold water/wash.